Need a bit of help with a pump. There's some small clips that hold the impellers onto the axles of the pump to stop them sliding up and down. The outer one on either side of my pump is gone and I've no idea what the type of clip is called to search for it. Anyone have any idea?
If you're a university student, there is guaranteed to be a professor or other faculty member somewhere experienced in the patent process. Just ask anyone that looks like they've been around for a while and they should be able to point you to someone that can help you.
Unless you have a pretty beefy computer power supply lying around your best option to power that sub is probably just buying a home audio amp or receiver. You could just run the car amp off a 12v battery inside but that would be the niggest of rigs and you'd have to charge the battery and shit.
Im planning a DIY project for some interior accents. I plan on soldering brass foil tape to glass to form a terrarium. I'm capable of doing this. My holdup is I have no clue where to begin looking for custom glass cutting service who also screen or silk prints onto glass. I can could cut the glass by hand and have it sent in for printing but id rather have it machined and printed. Anyone happen to know what I should be searching for? Is there a specific name for this service?
>>989538 I used to make them by getting the block of paper set up between two thin bits of wood, then clamping them down firmly- mark out the holes about 5mm-1/4" from the edge and then drill holes along the length with a small (generally 2mm) bit about every 1cm or so. Then take the boards off, get waxed cotton and bind the core of the pages together with a ringbolt hitch down the length. Nice thing about the ringbolt is that its got a bit of room so you can either sew the spine to it or it'll have enough 'meat'... Comment too long. Click here to view the full text.
The soles of my shoes have dried out and become porous, and developed cavities/holes. I can't keep wearing them until I've fixed the holes. How do I do this? I thought about just filling the holes with wood glue or something, would that work?
>>988292 I'm guessing it was a bad charger, I'm going to throw out all my cheap chargers soon and only use the reliable ones.
I just woke up one day and the battery was draining super fast (flat in 12 hours standby) and the phone was warmer than usual. Opened the back out of curiosity and saw the burnt ic. Not sure if it's clear in the image though.
i did it in my parents bathroom as a teen with india ink and a sewing needle it was 100% not safe but i didn't have any infections. however, it faded like mad so if you get it on the finger like in the op pic you're better off drawing it with a sharpie. I put my needles in boiling water for an hour and basically soaked them in rubbing alcohol to cool them down. I used piercing antiseptic for the aftercare.
How many of you guys have experience with modding a mechanical keyboard? I'm rocking a Steelseries 6GV2 (for 2 years now) and I still love it so much.
I really love the completely blank key caps on modded keyboards, but they are expensive and the enter key is sold nowhere (its this long enter thingy). I thought maybe sand the key caps and spray paint them. Maybe some more ideas I could do?
All trademarks and copyrights on this page are owned by their respective parties. Images uploaded are the responsibility of the Poster. Comments are owned by the Poster.
This is a 4chan archive - all of the content originated from them. If you need IP information for a Poster - you need to contact them. This website shows only archived content.
If a post contains personal/copyrighted/illegal content you can contact me at email@example.com with that post and thread number and it will be removed as soon as possible.