Hey /g/angsters, this stuff keeps your circuit board or general wire matrix free of outside buttfucking via moisture and thermal/physical shocks.
How do I make this shit myself? I'll need a lot,
and $20 for every few miliLiters won't cut it financially. Anybody have any tips? or a cheaper provider?
and I don't want to spend
>>51941154
It doesn't cost that much, dude. Check amazon.
>>51941154
you could experiment with epoxies. if you need it rubbery, look into spray rubber or for tool handle dipping or whatever. If you don't need it transparent, of course. and mostr importantly meter whatever material you use.
I've always just put hotglue or kapton tape over anything important, but maybe you could use clear nail polish if mousture is an issue? Two part epoxy is also a traditional low-cost potting solution, though it will be messy for a big board like that.
>>51941344
Hotglue anon. There you go
>>51941154
pic related
Cum on it
>>51941344
>>51941214
>>51941552
>>51941569
actually i'm not using it for pic related, i'm using it to protect the exposed inductors on the motors for a drone i'm building.
I'm not sure how hot they're going to get,
but i'm pretty sure i should be using potting.
still, any help helps. I should've specified.
>>51942155
Edgy. Even though the FAA is planning on killing it with their regulations. Just make sure that you can see the drone at all times and get your , dick tattood by the feds so you can fly ur drones
>>51941154
rub weiner
>>51941154
There are a couple types. The epoxy stuff is expensive, but maybe you can get away with cheap acrylic spray. Urethane is also cheaper.
>>51942155
You mean the coils? There is actually stuff special for motors, it's a varnish that soaks in through the windings. You usually have to bake it, so disassembly of motor is required.
