How would you fix the hole at the top to make it be able to be strung for a necklace? It chipped when I tried to clean it.
Don't even know if this is the right board and didn't see similar threads in the catalog.
from before if it matters
that looks a though one...
My first idea would be to use an epoxy resin putty. People use it to sculpt.
Would probably put a large lump over the hole mould it into shape then add a new hole before it sets.
https://www.youtube.com/watch?v=yOvoLmUUB-A
>>916280
The easiest fix is to superglue a bit of wire or paperclip across the top. Maybe smooth out the broken edges first. Always clean before you glue.
>>916286
This is the neatest solution, though I have no idea how hard it is to make the shape right. Maybe you can fill the whole gap with epoxy and then re-drill the hole.
>>916280
Epoxy Kit look for Weicon
you could use the epoxy putty to mould a frame for it. I think you can get coloured epoxy so you could make something quite attractive.
You would only need a small bit and then press a bit of pattern into it with a pencil.
>>916305
A mix of these solutions epoxy some bracing over the gap and fill the hole while you're at it. Then drill a new hole.
Buy one of these for fifty cents
