Go to garage sale
Find a set of rust wood chisels for $1.00us.
This 1/4 inch chisel has the some issues with the edge.
Pic related
Try a rotary tool to grind the tip flat then resharpen. Any pics of the grips OP?
>>950084
Sharpen it back up. Maintain the main bevel. Apply a microbevel to finish it off.
Using the fine grit wheel on the grinder
Match the angle of the bevel
Be careful enough so I don't over heat the steel and destroy the temper.
Lightly touch the tool to the wheel.
The edge after the grinder.
You can see different facets where I didn't match the angle perfectly
But the chip in the corner is gone.
Fine grit diamond stone with some water
matching the angle.
The edge after just a few strokes on the diamond stone.
Moral of the story.
Don't be afraid to buy used tools,
>>950097
Oops.
Picture now attached.
>>950087
The handles.
The three piece set
The 1/4 inch in the middle was sharpened and hit with 0000 steel wool to remove the rust.
The other two will be next
But the race is on so will do later.
>>950098
No microbevel like I told you to do. Also, your sharpening job looks like shit.
5/10.
>>950109
Also I'll add for anyone reading this that is new to chisels or sharpening: the true test of a chisels sharpness is the ability to cut the wood without a mallet. If you can push the chisel by hand and make cuts into the wood, the chisel is good to go.
>>950109
Micro bevels
First thing I find on google is micro bevels are unnecessary and time consuming to create.
https://paulsellers.com/2011/12/going-against-the-gods-myth-busting/
>>950109
>microbevel meme
>>950109
Yeah but its not made of brass so Chris Swartz wouldn't approve anyway.
>>950122
Paul Sellers, the self proclaimed amateur woodoworker?
Well allow me to retort:
http://www.popularwoodworking.com/techniques/hand-tools-techniques/sharpening-chisels
http://www.inthewoodshop.com/WoodworkTechniques/BeyondSharpASharpeningStrategy.html
http://www.stewmac.com/How-To/Trade_Secrets/Sharpen_your_chisels_so_they_cut_like_razors.html
http://www.sawmillcreek.org/showthread.php?187711-micro-bevel-on-mortise-chisels-Is-it-a-yea-or-a-nay
http://www.antiquetools.com/sharp/sharpmicrobevel.html
https://www.canadianwoodworking.com/tools/bevel-chisels
Prosecution rests, your honor.
>>950122
Oh, and from your link, lol:
Paul Sellers says:
I wouldn’t try to persuade anyone. There’s two hundred years of craftsmanship to back up what we are saying.
So it's basically Paul's opinion and experience with no quantifiable evidence. No thanks.
>>950114
This has got to depend so much on what wood you're cutting. There's some difference between pune and ebony...