Bonding together enamelled wire

Thread replies: 5
Thread images: 2

Bean
Bonding together enamelled wire 2016-07-14 00:38:07 Post No. 1022399
[Report] Image search: [Google]

File: voice-coil1.jpg (39 KB, 500x334) Image search: [Google]

Bonding together enamelled wire Bean 2016-07-14 00:38:07 Post No. 1022399 [Report]

hey /diy/!

Just wondering if anyone has any experience creating the same sort of "solid-bar" effect that you get on voice coils on the actuators on hard drives?

I am thinking about maybe using epoxy to bond the coils together (i am slightly nervous that it may damage the insulation on the enamelled wire) and am also unsure whether to coat each layer or just the outside.

Of course i will probably try a few combinations but am just curious if anyone has tried something similar and if so if they had any hints or tips as my google-fu has failed me on this occasion.
Thanks!

pic related, voice coil in a hard drive

>>

Anonymous 2016-07-14 00:57:51 Post No.1022402
[Report] Image search: [Google]

Anonymous 2016-07-14 00:57:51 Post No.1022402 [Report]

File: stators.jpg (149 KB, 512x384) Image search: [Google]

149 KB, 512x384

>>1022399
You may do well to take a look over here:

http://www.fieldlines.com/index.php

>>

Bean 2016-07-14 01:06:27 Post No.1022410
[Report]

Bean 2016-07-14 01:06:27 Post No.1022410 [Report]

>>1022402
Thank you, ill check it out!

>>

Anonymous 2016-07-14 02:09:00 Post No.1022441
[Report]

Anonymous 2016-07-14 02:09:00 Post No.1022441 [Report]

>>1022399
place coil in container of coil varnish
pull vacuum on container
keep under vacuum for 10-20 minutes
release vacuum
remove coil
bake on low or allow to dry naturally

>>

Anonymous 2016-07-14 02:10:58 Post No.1022442
[Report]

Anonymous 2016-07-14 02:10:58 Post No.1022442 [Report]

>>1022441
should add:
coil varnish (dope) should completely cover coil
(full immersion)