Anyone here got experience with bending copper tubes? got some 10mm copper tube and was wondering if it would be possible to wind it around a 20mm tube. the plan is to make a coil that sould fit inside a 50mm tube. pic related
>>41459
I have no experience, but I heard that it's convenient to fill tubes with salt before attempting to bend, so as to prevent them from going flat like toothpaste tubes.
You should go to /diy/, they'll probably have more advice on this.
You can use solution of water and soap, fill the tube and freez it, if the tube fits into the freezer. then bend it, this methot is used for instyments like trumpet.