Hi
I need help opening up a bluetooth speaker. I'm making a new casing for it.
But it seems this thing has no screws. How can I open it up?
>>962483
>ib4 harmonics
>>962483
Dremel
I need a picture of the bottom to tell you where the concealed screws are.
Also, it's probably not going to make it sound better, and will more likely make it sound worse.
Looks cheap. Could be clipped or glued together.
Use a damn hammer and some WD-40
>>962483
Does it have small rubber feet on the bottom? Or a sticker? 9 times out of 10 the screws will be under those, if not then it's just glued, just find a seam and get a screwdriver/chisel/blade in the gap and twist.
Thanks to suggestions in this thread I found the first set of hidden screws.
I couldn't find the second set though and now I'm makings a mess of things. Where can I find the next screws now?
>>962603
in the other side then what we can see in the picture. the face where the speaker is at most likely snaps off.
if you're not using the speaker again, cut the red/black wires
>Lel hotglue.
>>962603
Try hooking a wire under the speaker grill and pulling that up, chances are it's just friction fit in there. Then on that side the speaker is probable screwed down to the plastic, you will probably have to cut those two wires and join them back up again once everything is out of the case.
MUSIC FEDORA
E
D
O
R
A